Introduction: Laser Cut Candle Holders
Following up on this amazing Instructables by Amanda:
https://www.instructables.com/id/Laser-Cut-Tea-Light-Candle-Holders/
I decided to make a derivative, both employing her designs and adding a few new ones.
Settings @VLS4.60
General Hard Woods
Thickness: 0.125"
Power 100%
Speed 11%
They fit nicely but do use some wood glue to ensure maximum durability.
Never leave wood candle holders unattended!! Hope you like it :)
https://www.instructables.com/id/Laser-Cut-Tea-Light-Candle-Holders/
I decided to make a derivative, both employing her designs and adding a few new ones.
Settings @VLS4.60
General Hard Woods
Thickness: 0.125"
Power 100%
Speed 11%
They fit nicely but do use some wood glue to ensure maximum durability.
Never leave wood candle holders unattended!! Hope you like it :)
Attachments
![Craft Contest](https://content.instructables.com/FT9/OP96/HH2VNRHH/FT9OP96HH2VNRHH.jpg?auto=webp&frame=1&width=320)
Participated in the
Craft Contest