Print-in-place Rolling Skateboards

Introduction: Print-in-place Rolling Skateboards

these are some print in place tech decks that are fairly fun to mess with, And they roll!! my suggestions is that if you are to print these, you should have the infill be at least be 50% so the axle does not snap when you are doing your tricks. this design was made in tinkercad. DO NOT print with supports!

Step 1: Supplies

  • 3d printer
  • filament
  • slicing software

Skateboard Contest

Participated in the
Skateboard Contest

Be the First to Share

    Recommendations

    • Stone Concrete Cement Contest

      Stone Concrete Cement Contest
    • Fruits and Veggies Speed Challenge

      Fruits and Veggies Speed Challenge
    • Make It Modular: Student Design Challenge

      Make It Modular: Student Design Challenge

    Comments