Push Block

4,045

72

2

Introduction: Push Block

Make a push block for safe operation of power tools like table saws and routers.

Step 1: Stencil

Stencil the handle of a saw onto a piece of wood stock.

Step 2: Shape

Cut the the handle to size with a jig saw. Use a router to round the edges and sand to finish.

Step 3: Base

Cut a piece of stock for the base.

Step 4: Router

Route the center of the base to accommodate the handle.

Step 5: Fasten

Screw the handle to the base.

Step 6: Grip

Glue the underside of a mouse pad to the base and trim the edges.

Step 7: Boom

Be the First to Share

    Recommendations

    • Plastic Contest

      Plastic Contest
    • The 1000th Contest

      The 1000th Contest
    • Battery Powered Contest

      Battery Powered Contest

    2 Discussions

    0
    Jesper75
    Jesper75

    4 years ago

    Mouse pad as grip, great idea!

    0
    gumby_kevbo
    gumby_kevbo

    4 years ago

    An improvement would be to match the grain direction of the saw handle. As shown the pusher handle may break at the narrow areas beside the finger slot. The handle on the saw won't.