Rate Your Whisky Coasters

For a whisky tasting I organised I wanted to aid the tasters with their tasting.

So I created 'Rate Your Whisk(e)y' coasters.

Step 1: Prepare for Lasercutting

I created the coasters in inkscape.

Used rectangles with round edges. (Dimensions 90-120 mm each)

Inserted the picture after.

Step 2: Start Lasercutting

After I created the file. It was ready for lasercutting.

(Notice: The file might need some tweeking depending on your specs)

I used MDF 4mm as base (300-600 mm)

It took me about an hour to complete.