Switch on and Shutdown the PC by RFID & IR

3,608

28

1

Introduction: Switch on and Shutdown the PC by RFID & IR

About: I love Science & Technology. Loves New Ideas.

Hello guys !!!

In this instructable we are going to switch ON and shutdown the PC using an IR Proximity sensor or a RFID Reader.

Due to my studies, I am unable to write this instructable detaily and I HOPE YOU CAN UNDERSTAND, PLEASE FEEL FREE TO ASK THE DOUBTS IN COMMENTS AND DON'T FORGET TO VOTE FOR ME.

Step 1: Parts Needed

Arduino (any version) x 1

IR Proximity Sensor x 1

RFID Reader x 1

Transistor C1815 x 1

Relay x 1

Bread Board and some wires

Step 2: Switching Using IR

If we place our hand or any other obstacle before the sensor the computer will be automatically switch on.

Wiring connection are shown in the picture and Arduino code is given here.

Step 3: Switching by RFID

Due to my budget problem I am unable to buy a RFID reader but I will tell you how to do that,

Simply, Connect RFID reader's Tx to Rx of Arduino instead of IR Sensor and upload the Arduino code given here.

Step 4: Enjoy

Now you can switch on/Shutdown your computer without pressing Power button by showing your hand before IR Sensor or showing your RFID Tag near RFID Reader. :)

Don't forget to vote for me.......

Tech Contest

Participated in the
Tech Contest

Teach It! Contest Sponsored by Dremel

Participated in the
Teach It! Contest Sponsored by Dremel

Summer #mikehacks Contest

Participated in the
Summer #mikehacks Contest

Be the First to Share

    Recommendations

    • Cheese Challenge

      Cheese Challenge
    • Back to School: Student Design Challenge

      Back to School: Student Design Challenge
    • Teach With Tinkercad Contest

      Teach With Tinkercad Contest

    Comments