Tutorial How to Use LORA SX1278 RF433

Introduction: Tutorial How to Use LORA SX1278 RF433

In this tutorial we will teach you how to make LORA-SX1278 RF433 to communicate with each other.

Supplies:

All the components you need in this project is:

1. 2x Arduino UNO

2. 2x LORA-SX1278 RF433

4. Jumpers

Step 1: Step 1 : Assemble the Circuit

By referring to the schematic diagram and pin number, assemble the circuit. Make 2 same circuit for this project. The first circuit as transmitter and the other one as receiver.

Step 2: Step 2: Upload Coding

Upload the coding for the transmitter and receiver.

Step 3: Step 3: Complete Your Project

Now you have all the "ingredients" needed to complete this project. We have made the step-by-step on how to complete this project in youtube. You can also refer to circuit diagram that we put to make sure you connect to correct place that you should.

Be the First to Share

    Recommendations

    • The 1000th Contest

      The 1000th Contest
    • Battery Powered Contest

      Battery Powered Contest
    • Hand Tools Only Challenge

      Hand Tools Only Challenge

    Discussions