USB Drive Butterfly Knife

Introduction: USB Drive Butterfly Knife

About: Young and creative kid turned mechanical engineering student at University of Pittsburgh. All posts here were posted when I was in highschool. New projects coming this summer.

 Do you want to show off your balisong tricks to your friends in school?
Are you looking for a cooler flash-drive?
FUNKYYYYYYYYY       TIMEEEEEEEEE!!!!!

Be the First to Share

    Recommendations

    • Toys & Games Contest

      Toys & Games Contest
    • Big vs Small Challenge

      Big vs Small Challenge
    • Fix It Challenge

      Fix It Challenge

    4 Comments

    0
    Doomog
    Doomog

    11 years ago on Introduction

    How did you form the platform for the pins AND make it stay to the naked chip?

    0
    skaterqwertyuiop
    skaterqwertyuiop

    Reply 11 years ago on Introduction

     I cut and drilled a piece of scrap metal. it looked like this- (o   o)
    Before i glued it to the drive, i put a layer of glue down and waited for it to harden (so the metal would not connect the parts of the drive). Then I glued the metal piece onto the hardened glue.
    I used a very powerful glue, I'll write the name later.