Hot Pocket Buckyball Shape

By in CircuitsArt

1,852

1

4

Introduction: Hot Pocket Buckyball Shape

By
About: I am a thinker, and I am a nerd/geek that also loves technology and computers equally. Going to be posting again soon afeter a very long hiatus....

The first step is to make a strand of buckyballs#

Step 1: First Step

make a link of 6 balls#

Step 2: Hexagon!!!!

M#ake giant hexagon out of all 216 magnets and make sure it has a hole in the center.

Step 3: The Tube

the tube you have to connect two sides together#

Step 4: Edge

fold over the edge and connect it to the tube as shown#

Step 5: Finished!!!!!

now do the same as the other side and then you will be done#

Be the First to Share

    Recommendations

    Digital Measuring Roller Using Microbit & Tinkercad
    Digital Measuring Roller Using Microbit & Tinkercad by Makertronics in Tools
    6 405
    Pocket Dice! Electronic Dice for Liars Dice and More
    Pocket Dice! Electronic Dice for Liars Dice and More by sunyecz06 in Electronics
    94 7.9K
    LED Chaser Circuit Without IC
    LED Chaser Circuit Without IC by NEW PEW in LEDs
    144 18K
    RGB Glasses
    RGB Glasses by Arnov Sharma in LEDs
    61 9.7K

    • Make it Glow Contest

      Make it Glow Contest

    • First Time Author Contest

      First Time Author Contest

    • PCB Challenge

      PCB Challenge

    4 Discussions

    0
    nerd7473
    nerd7473

    Reply 7 years ago on Introduction

    how about I don't magnets (If ingested) can stick to the intestines causing severe injury or even death