Introduction: Diy Paintball Barrel Shroud
I just made this for my pinball gun and wanted to share it.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Step 1 Materials
- 1-1/4" PVC pipe
- Two rubber bands
- Flat black spray paint (not pictured)
- Your Paintball Gun
Step 2: Step 2 Assembly
First, cut the PVC to the size of the part of the barrel that sticks out.
Spray paint the PVC pice flat black
In my case I have a Smart Parts SP1 with a CP barrel, and so I measured About 6-1/2"
Put the rubber bands acording to the picture.
Then slide in the PVC pipe covering the barrel.
Step 3: Step 3 Your Done
I did this to make my marker look different and give it that "tacticool" look. It just looks awsome.
Planning to make differnt ones in the future.