Introduction: Final Project Step 1 Grill Sub Assembly
This is an opportunity to show what you know about Inventor. This is not intended to be a fully detailed instruction but more of a road map to get you started a give some direction. This is part 1 of a 6 part project. Please see the attached file for details.
Attachments
Step 1: Model Grill Support.ipt
Create a new standard .ipt file and produce the model.
Step 2: Create Grill Square Rod.ipt
Create a new standard .ipt file and produce the model.
Step 3: Create Short Grill.ipt
Create a new standard .ipt file and produce the model.
Step 4: Create Center Grill Support.ipt
Create a new standard .ipt file and produce the model.
Step 5: Create Grill Handle.ipt
Create a new standard .ipt file and produce the model.
Step 6: Create a New Weldment.iam and Assemble
Create a new Weldment.iam and use the proper constraints to assemble the grill assembly.
Step 7: Create the Welds
Create the proper welds as indicated on the drawing.
Step 8: Save the Assembly
Save the assembly to be used as a sub assembly in the future.