Introduction: Hot Wire Foam Cutter
this is how to make a very good foam cutting table that has no limitations on size!
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Materials
this is what you need:
Hot Wire Cutter (craft store such as "Michael's")
1" to 1/2" pvc reducer
2 part epoxy
Step 2: Cut the Hole With Your Knife
cut a small hole about 1/4" x 1/4"
Step 3: Attach the Reducer
Epoxy on the reducer with the bigger end facing up.
Step 4: Mount It
now, mount the wire in with the handle in the box.
Step 5: Done
Plug it in, and turn it on!