3D Printed MB Jeep and M416 Trailer in 1:10 Scale
Knex Rock Bouncer
Knex Baja Truck
*other than the steering*
How do you get the front suspension to move up and down with the steering shaft. I fell short and ordered the parts, I built the model and it did not really move. Do you know why the travel was well lacked on the driver(left) side? Also, if you have a K'nex man can you put him(or her(your choice)) in?
Very cool. I favorited.
Knex Car Steering Mechanism With Ajustable Steering Ratio
Maybe you just are to hard on it?
I never had problems with it. Maybe you miscounted the parts?
K'NEX 4x4 W/ Working Suspension & Front Steering
Gworks has two, and not the one I was thinking of.
Does the all K'nex U-Joint have a better torque rating than the 3-D printed one?
Maybe you could reprint it on it's side.
Gworks has a small, but part consuming one.
You should post instructions. The suspension is the nicest I have seen in a while. 5 stars!!!
I don't know what happened to it. I got an email saying that it needed instructions and that it was off the sight. It's not in my published tab.
Thank you!!! :)
Like the detailed one that the 4x4? That is something I had going. I tore it out at the last minute.
Knex 4x4View Instructable »
K'nex Jeep W/th ModsView Instructable »
5 1/2 gears are the biggest. I use them.
you should post instructions
do you make cool vehicles
is their a possible steering mod that could be made???
The suspension is amazing.
Tools and Materials for Easy 3D Printing
Easy 3D Printing