AlanH183's instructable
Tell us about yourself!
- AlanH183 commented on Stormgarde_24's instructable How to Restring Your Guitar
- AlanH183 commented on Yonatan24's instructable Top 10 Ways to Cut Metal - Without an Angle Grinder!
View Instructable »Or... convert a cheap "wood only" 9" bandsaw to cut steel: https://www.youtube.com/watch?v=NIjzaDHslMs&t=30s
- AlanH183 commented on imee made's instructable DIY Electric Foundry for Metal Casting (120V)View Instructable »
Your calculations are inaccurate. You need to determine the impedance of the coil, not the resistance. I appears that you are using AC to power the foundry (you don't actually say so) so it is impedance that determines the current flow, not resistance.
- AlanH183 commented on AlanH183's instructable Angular Bluetooth SpeakerView Instructable »
Yes, I am happy yo do this. I am not very good at 3D CAD, but I will share what I have. Where is the best place to share files on here?
- AlanH183's instructable Angular Bluetooth Speaker's weekly stats:
- 296 views1 favorites4 comments
- AlanH183 entered Angular Bluetooth Speaker in the Audio Challenge 2020 contest
- AlanH183 commented on AlanH183's instructable Angular Bluetooth Speaker
- AlanH183 posted an instructable Angular Bluetooth Speaker
DON'T use pliers to pull the string pegs out of the bridge. This will easily cause the peg or the bridge to be marked. The end of the tuning crank is slotted to fit under the peg and then just pry up on the crank to lift the peg out.
Check the Youtube videos from Martin about how to put the new string through the tuning machine. Their method will prevent the string from ever slipping out.