Tell us about yourself!
Designing a Parametric "Print in Place" Hinged Container Using Autodesk Fusion 360
Beautiful snowflakes! It's important to note that your instruction to fold in thirds means a third of the angle - you start with a square-angle (90 deg.) with the double-folded square, then make two 30 deg. folds to get the thirds. Anyone who tries to measure the top edge of the double-folded square and divide this into 3 equal lengths will be disappointed!
Sounds like you have a "Blue" company, with 3 product models, but a search doesn't turn anything up. Do you sell kits for any of the models?
Robot Tools and Materials
Single Motor Bot
Getting Started With Robots
Introduction to Mold Making & Casting
Tools & Supplies
Mold Making & Casting Class
Welcome to Arduino
I find greater success removing labels if the the container is hot, but not wet! Pour a half measure of hot water into the container, cap it, then lift a corner of the label. If the container, and therefore the label glue, is warm enough, pulling the label straight out from the surface will almost always result in complete removal. Wet labels will always fail to come cleanly off.