DARKHOURS

Thank you it took about four times doing that and it finally worked Thanks again great project.

Hello I just finished mine today on the pcb from your files and uploaded your sketch and it works great but the flame is upside down! Everything is mounted right to your instruction. so not sure whats wrong. Any way to invert graphics? thanks

Here is a 3D printed stand for display https://www.thingiverse.com/thing:3247669

Here Is a 3D printed stand for display https://www.thingiverse.com/thing:3247669

I found i had to use Arduino:1.0.5 R2 to upload had the same errors with Arduino : 1.8.5

Thank You now i can complete project

Great Job I want to make one now could you send me the code Thanks Neil

You never mention your flight controller your using . That also contributes to the stability and agility to the flights..