author

Debbie742

Inbox View Profile
1Comments

Tell us about yourself!

  • Fingers are crossed you still pop in for any questions, as i see this post has been here for some time.I'd like to make some inserts for a crate, something like yours, but am fairly new to the woodworking. Did you use the table saw with a dado blade to make the bottle dividers? If so, did you just have a line on the board you were putting the grooves into, so you knew when to stop?? Is the board you are cutting laying flat, or standing up?? I'd like to do this to some 3/4 wood, (1x6, but i'd trim it to the width that would fit a blade) Sure could use any hints or pictures you may have handy...or a tutorial?Take care,Debbie.

    View Instructable »