Tell us about yourself!
i homed all the axes then sent the m114 command. After that ive sent my x axes to the ends that is 40mm each to the farthest end when i send them to the end and send this m114 command its showing me this SENDING:M114X:40.00 Y:40.00 Z:40.00 E:0.00 Count X:3200 Y:3200 Z:4000my question is why it isnt showing count values of xandy same as zand in the printer too the x and y axes are not hitting the ends as z my maximum position is set to 40mm too for all the axesThank you in advance
SENDING:M114X:40.00 Y:40.00 Z:40.00 E:0.00 Count X:3200 Y:3200 Z:4000 guys plz help why arent my x and y not reaching 4000
hey everyone im s confused about these sepper motors there are unipolar ones bipolar ones two phase ones and driving modes idk what all these means can anyone plz tell me what is two phase stepper motors are they just bipolar?and if i take a motor with chopping constant current drive will that work with a4988 driveer?
itd be so good if we can time them on app