1CommentsJoined December 27th, 2015

Tell us about yourself!

Complete Your Profile
  • "Simple" conversion of metal lamp to use touch switch

    Thanks for these instructions! I would try this, but it's a new lamp that I want to convert to a touch lamp for my mother and there is no threaded tube up the middle. The wire goes up an external tube and it's not threaded, so I think to make this work, I'd have to drill a hole in the base and attach the wire to the base with a screw and I'd rather not do this to a new designer lamp... I did buy the plug-in converter and it doesn't work - it makes the lamp blink on and off. I bought another, assuming that the converter was defective and got the same result. And it happened with two different lamps! Any idea what might cause that to happen? Thanks!

    View Instructable »