Tell us about yourself!
3D Printed Magnetic Levitation!
Infinity Mirror With Ultra Sonic Sensors
ESP8266 Temperature Controlled Relay
Stepper Motor Speed and Direction Control Without a Microcontroller
Acoustic Radar Display
NeoPixel Reactive Table
Arduino Air Bonsai Levitation
How to (and How Not To) Laser Cut Chocolate
Recycling Styrofoam (EPS) Into Useable Castable Styrene Plastic at Home
Arduino Laser Show With Real Galvos
Presumably this is all aimed at someone using an Ember 3D printer, and someone with a different printer should *NOT* choose "Autodesk Ember" in the first dropdown menu, and should probably adjust the various settings as best they can. In particular, the Y-offset should be set to 0. It seems to me that the right workflow then is to "Convert to Solid" then use (e.g.) Slic3r to produce the Gcode.Where can I find the "Advanced Support Generation Tutorial" as per the "Tip"?
DIY Home Automation with ESP8266 (Linknode R4) and Amazon Alexa
Soda can wind spinner
Hi,I'm an electronics newbie... can you clarify please. Your parts list says "IR Photo Resistor" and your circuit shows a resistor. But it links to "LTR-301-002 Lite On Phototransistor NPN". Is that correct? In that circuit, would the phototransistor essentially be functioning as a nil/infinite resistance IR photo-resistor?
I'd buy this kit if I could buy the board with the SMD devices pre-mounted.
3d printed medical vein finder
Thermoextensible 3D Printed Structures: Capabilities and Applications
Program arduino from raspberry pi