author
2CommentsJoined December 13th, 2015

Tell us about yourself!

Complete Your Profile
  • Hayabu commented on Michalsky's instructable 8x8x8 RGB LED-Cube3 years ago
    8x8x8 RGB LED-Cube

    If it helps, this is the code that I use for tasting the leds.I connect the arduino via usb (for power) and use the reset button on the board. also from each pin I use the resistors (betwen board pins and led pins) already bought for the project (120, 180 and 220 ohm).

    If it helps, this is the code that I use for tasting the leds.I connect the arduino via usb (for power) and use the reset button on the board. also from each pin I use the resistors (betwen board pins and led pins) already bought for the project (120, 180 and 220 ohm).

    hello, first of all, let me thank you for all your work and for sharing this with us, it is a very detailed project. after I watch it I've decided to make my own rgb cube based on your specs.after 2 months of preparation and work I've finally made it! it was my very own arduino project, therefor i have some minor problem understand the code and also to build it. but, again, your code files were excellent. at this moment, I have some minor problem on make it work. on the first power on i had layers 2,3,4,5,6 and 7 in white color. after a short inspection when i discover that i put, on Push Pull Line Driver exit Latch on Data and viceversa. I correct this error and now I have 3 led on green and one column on blue no matter what i do. do you have any idea why?maybe it is possible to send...

    see more »

    hello, first of all, let me thank you for all your work and for sharing this with us, it is a very detailed project. after I watch it I've decided to make my own rgb cube based on your specs.after 2 months of preparation and work I've finally made it! it was my very own arduino project, therefor i have some minor problem understand the code and also to build it. but, again, your code files were excellent. at this moment, I have some minor problem on make it work. on the first power on i had layers 2,3,4,5,6 and 7 in white color. after a short inspection when i discover that i put, on Push Pull Line Driver exit Latch on Data and viceversa. I correct this error and now I have 3 led on green and one column on blue no matter what i do. do you have any idea why?maybe it is possible to send me an email address to discuss in detail in order no to pollute this topic.thank you in advance for your reply.regards,

    If it helps, this is the code that I use for tasting the leds.I connect the arduino via usb (for power) and use the reset button on the board. also from each pin I use the resistors (betwen board pins and led pins) already bought for the project (120, 180 and 220 ohm).

    View Instructable »