Tell us about yourself!
Casting In Pre-made Molds
Atta-boy, like this very much,thanks for thinking so hard. I'll give it a try.
neat idea .....where is the plug?
hammer a nail into the side of your workbench and spin the blade lightly. mark the high side and spin again, if it ends with the same side up grind a little off the low side to balance the blade. also I suggest not using wd-40 Anti seize compound does a much better job available at the local auto parts store. It is worth keeping around for anything you want to eventually take apart, in gold or silver. Gold for higher temp.thanks bye
p.s. Block the blade with of wood 2by4 works well so the blade is in the center of the 4 side against the housing. If you can't brake it loose with a large socket large or open end wrench get some Kroil oil. It comes in a spray can also at auto parts store and is the best for breaking loose rusted bolts.remember if you break the bolt you have really compounded your situation,watch those fingers.bye
Concrete Mushrooms -- Yard Art