JohnnyLightning

This project was on the back-burnrer for me for a long time but I was excited about it the moment I saw it.I ended up using a 3/8" piece of acrylic, masked and frosted with spacers between the numbers and acrylic.Mounting was a pain. I was dealing with a roughly finished wall and realized that aligning the mounting holes on the plaque to the wall wasn't going to be easy so as DoltHerselfDiva explains, I also made a template to help guide where the holes needed to be drilled out.The entire assembly was attached with four, #10-2" Tamper-Pruf stainless steel screws and lead shield anchors.Thanks so much cornflake for the great Instructable and for everyone's mods and contributions.