Awesome, that helps out a bunch, thank you!Also, a major problem with my last record is that it skipped on the louder parts of the song. Any suggestions to remedy this? In the video, you can see that I had to prevent the needle from skipping whenever one of these louder parts came up. On the second song/chant on the record, I practically had to guide the needle the entire way through. If my hand would not have been there, the skipping would have been horrendous.Here is the video: Thanks again for your help!
Thanks! So I am looking into making another one, and this time at potentially a different speed. My biggest question is what do you mean when you say "For example, my laser cutter melts anything above 2.5kHz at 45rpm, so I set my anti-aliasing filter cutoff to this same frequency."? On my last project, I just followed what you did and set it at 2.5 kHz since I was going to be making a 45rpm speed record. Will I need to change the kHz for say a 33rpm or 78rpm record?Thanks!