author

KOTSOS5

1
Inbox View Profile
65Comments

Tell us about yourself!

  • I followed all your instructions cause i'm totally noob with raspberry but I had some problems with GLSlideshow (didn't show all pics, or got blank after 12 hours like all screensavers) but I've used a program called feh and made it boot at startup, and it works totally perfect, thank you very much again!

    View Instructable »
  • Super inspiration, followed your steps and did it, thank you very much!

    View Instructable »
  • KOTSOS5 commented on Tiobel's instructable Mail Alarm

    Hi very nice project, you could also use Blynk! , I think it's a lot easier! :)

    View Instructable »
  • Are you sure that you've connected the right output of arduino to ledstrip's DIN? Also be sure that there is a common ground between aruino and led strip, sometimes if you power a led strip through a power source and don't connect both grounds together strips tend to do crazy stuff....

    View Instructable »
  • KOTSOS5 commented on Suki_ete's instructable Coconut Desk Lamp

    Bravo! Poly kalo, well done! :)

    View Instructable »
  • Bravo! Poly kalh doyleia! Voted!

    View Instructable »
  • KOTSOS5 commented on IvanB147's instructable Party Lights

    While everything works fine, when I put the sound visualizer, the led strip lights at random times, no matter what the sound is, I guess the max4466 picks random noise but I can't overcome this, even if I change the record noise level, any suggestions?

    View Instructable »
  • Hi, if we want to upload it through arduino, what steps whould we follow?

    View Instructable »
  • Hi I've finally made it! Thanks for the contribution. What problems I've faced was basically the PIR stuff. so i've changed these here :1) int alarmValueTop = LOW; // Variable to hold the PIR status int alarmValueBottom = LOW; // Variable to hold the PIR status2) pinMode(alarmPinTop, INPUT); // for PIR at top of stairs initialise the input pin and use the internal restistor pinMode(alarmPinBottom, INPUT); // for PIR at bottom of stairs initialise the input pin and use the internal restistor3) if (alarmValueTop == HIGH && downUp != 2)if (alarmValueBottom == HIGH && downUp != 1)4) THE MOST CRITICAL! try this project in dark, because I was putting my hand in front of the LDR to raise the resistance while I had my light turned on the led strip wasn't performing how it supp…

    see more »

    Hi I've finally made it! Thanks for the contribution. What problems I've faced was basically the PIR stuff. so i've changed these here :1) int alarmValueTop = LOW; // Variable to hold the PIR status int alarmValueBottom = LOW; // Variable to hold the PIR status2) pinMode(alarmPinTop, INPUT); // for PIR at top of stairs initialise the input pin and use the internal restistor pinMode(alarmPinBottom, INPUT); // for PIR at bottom of stairs initialise the input pin and use the internal restistor3) if (alarmValueTop == HIGH && downUp != 2)if (alarmValueBottom == HIGH && downUp != 1)4) THE MOST CRITICAL! try this project in dark, because I was putting my hand in front of the LDR to raise the resistance while I had my light turned on the led strip wasn't performing how it supposed to do and while it started to work right eventually it was stopping. SO try this project at dark! I hope you've managed to solve the problem when the led strip is on and the LDR becomes <600

    View Instructable »
  • well done, nice project, voted!

    well done, nice project, voted!

    well done, nice project, voted!

    View Instructable »