Tell us about yourself!
I hope you know that it will fall apart fairly fast since you didn't use Marine Plywood or fiberglass any of the joints.
After doing the mustard dip, if you don't like the results can you just polish the line(s) away?
I f you don't have a bending spring fill the tube with sand and bend it then let the sand run out.
What is the purpose for doing this, reversing the steering direction?
Thank You, I actually know how you did it BUT, I know a lot of beginner woodworkers need more info which you said you will provide, for clarity. Good Job.
Good answer. I was thinking that a small piece of heat shrink could be installed on the ends of the cotter key insulating them and making them safe should they touch the circuit board, but I'll assume there isn't enough space now.
Nice job. It would have been a lot better if you had shown in a little more detail how you attached the top of the stringers to the house, to make it easier for a novice to understand what you did.
EXCELLENT POINT MAKING THEM AMBIDEXTROUS
The new connection is BACKWARDS to what was original. Why didn't you repair on the same end of fob that was broken?
IS IT MICROWAVABLE
You should have "angled" the bottom end of the legs OUT further than the top of the leg i.e. if the top of the legs are 18 inches apart then the bottoms should be say 24 inches apart, giving the stand more steadiness
Just sayin is:Used at the end of a statement to indicate to the reader that the writer is a making a passive aggressive comment while trying not to offend ...
THIS EXPLAINS HOW TO STRENGTHEN THE BOW AND YOU CAN USE THIS METHOD TO INCREASE THE DRAW USING FIBERGLASS DRIVEWAY MARKERS. HOPE THIS HELPS YOU
Tip place the mandolin in the sink and have cold running water over it as you slice the onion ..... no tears