Tell us about yourself!
- MatthewG210 completed the lesson Integrated Circuits in the class Electronics Class
- MatthewG210 commented on HackerBoxes's instructable HackerBox 0031: the Ether
- MatthewG210 commented on HackerBoxes's instructable HackerBoxes 0017: Power MakerView Instructable »
My buck boost converter currently only outputs 54 volts. Even with changes in the variable resistor, there is no change. Checked to see if the resistor still works, which it does, and rest of power supply is working fine. Any solutions? It was working fine then I had to re solder the OUT- wire and it hasn't worked since then.
- MatthewG210 commented on HackerBoxes's instructable HackerBoxes 0021: Hacker Tracker
- MatthewG210 followed HackerBoxes
By HackerBoxes
- MatthewG210 commented on HackerBoxes's instructable HackerBox 0027: CypherpunkView Instructable »
I've installed the driver for the STL-LINK and am still receiving the same "No ST-LINK detected" error. Any suggestions?
- MatthewG210 commented on HackerBoxes's instructable HackerBox 0025: Flair WareView Instructable »
The link seemed to work but attiny does not show up under the board managers.
- MatthewG210 commented on HackerBoxes's instructable HackerBox 0025: Flair Ware
![DIY Lab Bench Power Supply [Build + Tests]](https://cdn.instructables.com/ORIG/FMA/1S57/JXITX53E/FMA1S57JXITX53E.jpg?auto=webp&crop=1.2%3A1&frame=1&width=270)
Can anyone give more in depth instructions on the backSoon code? Not sure how to access the webpage that's supposed to be brought up.