How to Add an Air Receiver Tank for More Compressor Capacity
Scratch Built Acoustic Absorbers for Bedroom Studio
Laser Cut Machinist Toolbox
Humour? I was deadly serious :-)
Small Vertical Storage RackView Instructable »
Carbon Rods: I thought they were for cutting steel? (like a cheap plasma cutter)Voltage: Even through spot welders use low voltage, I don't see why we need to rewind stick welders to get lower voltage? When current is flowing through the spot, it is shorting out the transformer and will be approaching zero volts? Sort of like when you get a short arc welding stick "stuck" and it glows red hot until you lever it off again!As long as your old transformer welder can deliver the current, you clamp, switch it on for a second while increasing clamp pressure, and switch off again before unclamping?
Internet Radio Using an ESP32
What Is a Bad Capacitor?
Thien Baffle Dust Extractor With Quick Change Bucket
Electrolytic Rust Removal Aka Magic
Neat enclosure, but would it cool enough in air?(versus water, which is much more dense and cools better)
Another method for the brave: steam and clamp.If it is a thick slab, drill on the hidden side so the steam penetrates.