Hi may I know where you bought the motor hub for the N20 motor you are using for the Baransu project? thanks.
Merry Christmas to you and your family Jon. If you don't mind may I trouble you to include the STL for the footing so I can print it in flexible PLA? Thanks again :-)
Still deciding what message to put or perhaps an image :-) Nice project Jon as usual :-) Thanks for sharing
Intro to Fusion 360 UI
Sketch the Lamp
3D Design Class
Introduction to Fusion 360: Design a Lamp in an Hour
Thanks Jon for the end caps STL. I have started your 3D printing classes in Instructables and hopefully have enough time to learn some more techniques. My first fusion360 project will be to create a generic enclosure to fit 3 joysticks with an arduino and servo controller shield. This will be able to control at most 6 servos. I will use this to control Baby Bastion and a robotic arm that I had earlier printed and was juyst waiting until I can create the servo controllers.