Tell us about yourself!
Platform Bed With Drawers
Cheap, Easy, Low-waste Platform Bed Plans
Making a Simple Kydex Knife Sheath
I used 2x2s instead of 1x2s for the incline portion and 2x4s under the lower seat for additional support. I’m 260 lbs and have pressed 250 on it without any cracking so it will easily support 500 lbs. There is a little wobble on the bench when fully inclined but not enough to warrant modifying it. I’ve been happy with it!
A screen spline tool works great for the folds.
I watched videos until my brain hurt trying to learn how to make a box for a large picture frame I built. Thank you for explaining this in such a simple way and including the template. This is exactly what I needed!
Cardboard Box Template
Thanks for the great instructable! I used 1x6 cedar boards to frame a map showing my brother’s house from 1936.
Picture Frame With Corner Splines
Rustic Picture Frame
DIY Cutting Board (With 3 Tools!)
Chevron Farmhouse Coffee and End TablesView Instructable »
The Simplest Doweling Jig for Accurate Joinery
Flaming Halloween Jack-o'-lanterns
Simple Corner Clamp Jig
Great suggestion about sealing the end grain. I plan to seal the plywood once it has dried out and expect to have to replace the plywood eventually.
I have used a spotter a couple of times with no problem. You could always leave more space in the rear.
Use deck screws as spacers between the boards to allow for drainage.
Outdoor Weightlifting PlatformView Instructable »
My Home Made Shop Vac Adapter for DeWALT DWS779/ DWS780 Miter Saw
Super Easy Cyclone!
Make a Woodshop Pre-filter (aka Cyclone) for $8
Thanks for the excellent write up!
Thank you for the excellent Instructable!