Tell us about yourself!
- SeanH10 commented on PigWhistle's forum topic Make use of iCamera 1000 units?
- SeanH10 commented on PigWhistle's forum topic Make use of iCamera 1000 units?View Topic »
This is a setup guide that i made. Your Welcome everyone that is looking for this!!
- SeanH10 commented on PigWhistle's forum topic Make use of iCamera 1000 units?
The following installation hints should be noted:1. Take care not to install facing direct sunlight, bodies of water, or areas of moving shadows as these can lead to unintended triggers. 2. Do not position the PIR camera facing a window or direct sunlight. The device is also not suitable for using in draughty area where air conditioner or fan is installed. The excessive wind may cause false video triggering. 3. Avoid aiming directly near heat sources, such as fires, radiators, boiler, air conditioners and so on. 4. Mount the PIR camera where possible, so that the logical path of an intruder would cut across the detecting area rather than directly towards the device.
updated information
now you will want to enter your camera informationIP Host name= your cameras ip address. make/model:= iControl iCamera-1000 (pic 1)then click okthen you should see the following (pic 2)Change to the following (pic 3)then Click on audio (pic 4)change to (pic 5)then click motion/trigger and change to "whatever settings you want" (pic 6)then click record (pic 7)change to "continuous or when triggered. Option is up to you." (pic 8)THEN YOU CAN CLICK OK
View Topic »updated information
- SeanH10 commented on PigWhistle's forum topic Make use of iCamera 1000 units?View Topic »
im currently using without xfinity. Depending on what 3rd party service you will be able to record 24/7. As well as be able to view live or depending on setup back dated recordings from your mobile device or pc. From within and out of network.
Every step will be the same, however, if the icam2 was updated to the latest firmware you be unable to access the GUI. I have a code and some instructions on how to view the GUI with this firmware I'll look for and send you later.