ShashiK3's instructable
Tell us about yourself!
- ShashiK3 commented on biskis's instructable Install Node.js and Npm on Raspberry Pi
View Instructable » - ShashiK3 commented on TheTNR's instructable Music Spectrum With Digital Clock and Temperature
- ShashiK3 commented on innovativetom's instructable Wemos ESP8266 Getting Started Guide With Arduino IDE
- ShashiK3 commented on TechMartian's instructable ESP32: How to Interface LCD With ESP32 Microcontroller Development Board
- ShashiK3 commented on Mitchell Paull's instructable Raspberry Pi Motion Detector and Alert System
- ShashiK3 commented on Arduino12345's instructable Led Chaser With ONLY ONE ARDUINO PIN
- ShashiK3 commented on N.fletch's instructable Solution: Avrdude Stk500_getsync(): Not in Sync Resp=0x30 Error for Arduino
- ShashiK3 commented on Mr innovative's instructable DIY Arduino Based Automatic Wire Cutting Machine
- ShashiK3 commented on anuragan's instructable How to Build an EasyF450 Fpv Quadcopter
- ShashiK3 commented on hypnotistas's instructable Augmented Reality Using Unity3D, Vuforia and Arduino
- ShashiK3 commented on shadow501's instructable ACCELOROMETER WITH Adxl 345
- ShashiK3 completed the lesson Introduction to Mold Making & Casting in the class Mold Making & Casting Class
- ShashiK3 commented on amprasanna's instructable Connect Raspberry Pi As a Device to IBM Watson IoT
- ShashiK3 followed amprasanna
- By amprasanna
- ShashiK3 commented on Amun_Ra's instructable Simple 3-8 decoder / demultiplexer tutorialView Instructable »
What if I want to light up all the LEDs at the same time ?
- ShashiK3 commented on SagarA19's instructable How to Program the ATtiny2313....
Where did you get this ? in Bangalore.
View Instructable »For beginners which is the low end chipset in the Atmel family that you would recommend.
- ShashiK3 followed Reichenstein7
- ShashiK3 commented on adafruit's instructable PIR Motion Sensor Tutorial
Still not working - so I have a trick - If I put a small screw driver tip in between the Potentiometer - and just make some movement - I see that it will trigger some 'motion' activity on the PIR ! thats not acceptable - but for demo purposes thats what I use. Just stick in the screwdriver -but just wave the screwdriver tip in between the pots to see the activity.
View Instructable »I have a small trick - If I wave the tip of the screwdriver in between the potentiometers slightly -then I see some motion detected activity. That's not acceptable -but it works for my demo purposes.
