Tell us about yourself!
Making the actual brains looks very high-effort; did it take long? I can just see myself spending hours on it!!
The higher RPM means you can cut with significantly less pressure and therefore have far more control. I really suggest you overcome the fear - if you’re happy with the handheld circular saw then you already know how to handle similar tools safely.
I guess my point is that you don’t need to worry :)
Terrified of an angle grinder but perfectly happy to use a hand held circular saw?!
I mean you’re not wrong there, the time (and elbow grease) saved over a hacksaw is the real benefit
Good point in terms of the signal propagation; hadn't considered that. Might need to look into adding that into my current setup!
Is there any benefit to this over solutions such as OpenHAB or Home Assistant which have similar plug and play functionality along with very powerful automation options?Also, given the ESP8266 allows very cheap wifi control of devices (see: Sonoff) is there a benefit to using RF given the prevalence of wifi in homes?
The mythical store you can get to in under two minutes, frisbrob.
Internet of Things Class
Circuit Board Design Class
3D Printing Class
Isn't that only if you use the "bunny ears" technique?
Isn't that only when you use the "bunny ears" technique?
The "square knot" shown above may also be known as a "reef knot" - at least it was when I was in the Scouts!