Tell us about yourself!
Tee Slot Drill Press Clamps, Easy and Quick
A Software-Defined Radio on a Shoestring
Adjustable Shelving for Part Bin Organizers
Motion Controlled Timelapse
3D Printed Glass Bottle Cutting Tool
Geneva Roller Ruler, a Pocket Sized Infinite Ruler
Internet of Things Class
Do you have a link to it? I would like one and not sure if I want to build or buy.
Any suggestions on where to get starter?
Thanks for the pointer, I went to nextdoor.com a couple hours ago asking if anyone had some.
Yah, I don't like the single in the center idea and the mechanics of using gearing to only have a single motor has similar draw backs. Would you need that strong a motor? Seems that spinning the rod around would not need that much strength but I haven't thought through the torque needed.
I was thinking the same thing a jack screw (I had a table I bought from Boeing Surplus that worked like that). The thing I'm wrestling with is how to keep if from getting wracked in the raise/lower scenario. Some kind of rails would be needed.The one thing I didn't like about the old table I had was carriage required to do it took up a lot of space so I would want a motor and jack screw to be in the leg(s)...do I need 2 stepper motors (1 per side) or can it be done with 1.
Very cool instructable, thinking about doing this but going 1 step further and making the table/desk to be able to be raised and lowered.
De-Rust Your Old Table Saw
Electronics Soldering Mobile Workshop
Homemade liquid nitrogen generator