
- Unsafe At Any Speed commented on Konstantin Dimitrov's instructable Arduino Capacitive Sensor in Less Than 2 Minutes
- Unsafe At Any Speed followed comodore
- Unsafe At Any Speed commented on raulkaap's instructable A simple protocol for making iron(II, III) oxide (magnetite)
I did too, lot of fun!
View Instructable »I've made this for a few years now, except I did not use heat to evaporate the red liquid, just room temperature. After it's burned, it will go from a reddish-brown, completely non-magnetic solid to a black, magnetic dust. The material can actually burn on it's own, like an incense that emits formaldehyde. I have to wonder if I made a peroxy-acetate instead of an acetate.
- Unsafe At Any Speed commented on tomasdecamino's instructable Simple Arduino XY Plotter
Typo.........Position
I tried a few things, adding the 180 in the program, reversing the motors positions, reversing the motor plugs, using different values for ARMLENGTH. It still does not work. One thing I did not understand, how did you align the motors with the arms? I just made the motors position at 90° and lined the arms up in the middle.As you can see in the picture, the arms are longer than the Popsicle sticks in your example, it is 125mm from motor to motor.
I tried a few things, adding the 180 in the program, reversing the motors positions, reversing the motor plugs, using different values for ARMLENGTH. It still has problems. One thing I did not understand, how did you align the motors with the arms? I just made the motors potion at 90° and lined the arms up in the middle.As you can see in the picture, the arms are longer the the Popsicle sticks in your example, it is 125mm from motor to motor.
View Instructable »I tried a few things, adding the 180 in the program, reversing the motors positions, reversing the motor plugs, using different values for ARMLENGTH. It still does not work. One thing I did not understand, how did you align the motors with the arms? I just made the motors position at 90° and lined the arms up in the middle.As you can see in the picture, the arms are longer than the Popsicle sticks in your example, it is 125mm from motor to motor.
- Unsafe At Any Speed commented on technovative's instructable How to get FREE Atmel ChipsView Instructable »
They are both the same company now!:-)
- Unsafe At Any Speed commented on tomasdecamino's instructable Simple Arduino XY PlotterView Instructable »
Thomas,I could not get it to work .The X, Y coordinates fail to come out right. I tried 0,0 - 0,50 50,0 - 50, 50 to make a square but it comes out more as a big triangle with 0,0 and 50,50 going to the same point.Also, I notice the servo motors are mounted with one upside down in some pics and the same in other pics. -Thanks
- Unsafe At Any Speed commented on ramymounir's instructable Balancing Plate Game - Ramy Mounir - MAKE Course!
This would make a great car cup holder.Just mount it on the dash and have it sense the car's motion.It should and hold the cup perfectly steady!
View Instructable »This would make a great car cup holder.Just mount it on the dash and have it sense the car's motion.It should hold the cup perfectly steady!
- Unsafe At Any Speed followed tomasdecamino
- Unsafe At Any Speed commented on tomasdecamino's instructable Simple Arduino XY Plotter
A very good and useful project!I will have to make one.Thanks for posting this.
.
View Instructable »Get a board from eBay, it's cheaper than an official Arduino. Like this one:
You should post new youtube links. Both are dead.