Tell us about yourself!
- VajkF commented on PerAnders's instructable Magnetic Soldering Aid
- VajkF commented on Johan Link's instructable Ball Balancing PID SystemView Instructable »
You can do this without a custom pcb...
- VajkF commented on YADUKRISHNAN K M's instructable Working "MEGA 555"View Instructable »
This is awesome. Both the idea and the execution!!You make it a bit smaller, and can get into the counterfeit chip business ;-)Kudos to you
- VajkF commented on kinjja5's instructable Outdoor Pizza OvenView Instructable »
What is holding the outer formwork in srep5?
- VajkF commented on DIYJRAY's instructable Bed Slats ImprovementView Instructable »
Having a thick ribbon between the rail and the slat prevents noises when you move in the bed. I always use the staple and ribbon, but screw the ends of the ribbon to the rails.
- VajkF commented on csledbetter's instructable How to Fix a Hole in a Hollow Core DoorView Instructable »
Man, you are a genius.
- VajkF commented on marciot's instructable DIY Laser Steering Module for ArduinoView Instructable »
I cannot help in the control problem, but have a tip for the solenoid drivers: use a stepper driver stage. Like L298 based one. You will have bipolar drive, can use higher voltage, it is prepared for high frequencies. Will handle pwm, is regularly used to drive dc motors.
- VajkF commented on Sammy50's instructable Homemade ThermocupView Instructable »
What printer did you use?
- VajkF commented on ShakeTheFuture's instructable Make an Oscillating Tool From a Tooth-BrushView Instructable »
Where are the files?
- VajkF commented on MrCraft's instructable Wall Mounted Folding ChairView Instructable »
Super cool. Instant get.
- VajkF commented on j2pierson's instructable Best Ever FOG Juice for Fog MachinesView Instructable »
R u sure?
- VajkF commented on macmillj's instructable Sully From Monsters IncView Instructable »
Instant get!
- VajkF commented on SebastianH84's instructable WARNING!View Instructable »
Using a strip with built in usb charger to provide the power to nodemcu board is a brilliant idea. Really cool. I am ashamed I did not think on this.
- VajkF commented on ericsnis's instructable Router Bit Storage BoxView Instructable »
Having both 8 and 12mm holes in the same block is a brilliant idea!
- VajkF commented on Simon Kitt's instructable Large Off Camera Ring LightView Instructable »
Dude, this is still a ring light, just too big to mount on the lens. You do shoot thru the hole in the middle.
- VajkF commented on AlexGyver's instructable DIY vacuum chamber for experimentsView Instructable »
Where did you get those tiny fittings and valves? I must make this immediately!
- VajkF commented on toxuin's instructable Convert a unipolar stepper motor to bipolarView Instructable »
One note: never remove the rotor from the frame. It can demagnetize if pulled out. When you put it back again, it will be weak. Don't ask how I know.
You should move the magnets far from the soldering. Heat does destroy the magnets. Don't ask how I know.