Varen Greycloak's instructables
Achievements
1+
Featured Instructable
Earned a bronze medal
- Varen Greycloak's instructable Ancient Style Oil Paint's weekly stats:
192 views3 favorites0 comments
- Varen Greycloak posted an instructable Ancient Style Oil Paint
- Varen Greycloak posted an instructable Easy Homemade Milkshakes
- Varen Greycloak commented on GreatScottLab's instructable DIY Buck/Boost Converter (Flyback)View Instructable »
Do you think I could use this to run a circuit on exactly 3v from an 18650 lipo?
- Varen Greycloak commented on hanzablast's instructable 10 $ WIFI 16dBi Super Antenna PictorialView Instructable »
how would I go about adapting the BNC connecter to Ethernet or USB?
- Varen Greycloak followed JRV31
- By JRV31
- Varen Greycloak's instructable $20 Softbox's weekly stats:
- 1,144 views6 favorites0 comments
- Varen Greycloak posted an instructable $20 Softbox
- Varen Greycloak commented on mrcrumley's instructable How to Make a Synthetic DiamondView Instructable »
I'm going to attempt this in the near future with graphene, hopefully I can produce some diamond fragments. The impurities in yours were likely due to the clay and binders.
- Varen Greycloak's instructable Chicken Bacon Ranch Wrap's weekly stats:
- 110 views11 favorites0 comments
- Varen Greycloak's instructable Patina of Copper's weekly stats:
- 546 views10 favorites0 comments
- Varen Greycloak posted an instructable Chicken Bacon Ranch Wrap
- Varen Greycloak posted an instructable Patina of Copper
- Varen Greycloak commented on mikeasaurus's instructable Direction projectionView Instructable »
Possibility of glare, on top of that most of the time those are only a few inches high.And in my car I can only see the hood at a very steep angle because of its slope.
- Varen Greycloak commented on ygujarati's instructable Mirror Finishing A MetalView Instructable »
hmm, going to try this with sheet aluminum.
- Varen Greycloak commented on Varen Greycloak's instructable Electro Etching CopperView Instructable »
Actually it's electrical tape, I just cut the shape with an exacto-knife.(I also have yellow, blue and red)
- Varen Greycloak posted an instructable Electro Etching Copper
- Show More Activities
