Tell us about yourself!
Morphing Digital Clock
I made one a few years back. To keep enough oil in the jack, I removed the rubber fill plug and threaded it for a 1/4" NPT fitting, and used an old lawn mower gas tank as an oil reservoir. Used 2 old car hood springs for the ram return mechanism. Worked great.
Fix a Speaker by Replacing the Foam Edge
Something I learned the hard way when epoxying the switch to the valve stem... In the center of the plastic knob, you'll see a metal post. This post does NOT rotate when the switch is turned. After ruining one switch, I've learned to mask that post before gluing. Only a tiny bit of tape or sticky label is required. J-B Weld works _very_ well, and will cement the post and knob together, twisting it off and ruining your switch. I suspect that this was "Slsmith65"'s problem in the comments below.
Arduino Simon Says Game
ThermoClock: An OpenSource Arduino UNO OLED Clock That Also Measures Temperature
Great Projects from Old How-to Magazines
CD case storage for router & drill bits
wooden beer crate
Tough Cheap Work Bench (My Bowling Alley)
The time-bomb clock
copper cuff bracelet from copper tube
A Simple Dashboard Cam Setup
How to Make a PVC Rocket Cannon
laptop stand made from pvc pipes
PVC and pegboard desk/workbench
Forcibly Aging Wood
HomeMade Modern DIY Concrete Pendant Lamp
Modern Indirect Multicolored Accent Light
PVC Dremel drill press
How to fix a slowly charging android smartphone + enhanced privacy
MOTION SENSOR .... Good to Go,Quick & Easy...
Recycled Hard Drive Desk Clock
Faucet Night Light
DIY Printed circuit board
Table saw extension
Credit Card iPhone Stand