Tell us about yourself!
Star Tracker Using 28BYJ-48 Stepper Motor, Arduino and LCD Display to Vary Speed.
100% Homemade Lathe
How to Make a Router Circle Cutting Jig
Hi Thanks that worked, no idea why I did not think of it! ULN2003 Stepper Motor ,yes it is a uni-poplar stepper motor but changed by following the instructions break the red wire circuit under the blue plastic cover at this sitehttps://simvim.com/tech_28byj.html .
Hi Thanks I made the changes you suggested I am getting a small partial turn. I have used smaller numbers "shootingsteps" 2,4 6. rather then the 10,20, 40 numbers.I read some more on easy drivers and realized the easy driver default to 1/8 step, read more still not sure how to change it to full step? I do not understand how to "You can pull either or both to ground" Is it in the physical wiring or in the code?"You can pull either or both to ground to select the other 3 modes if you want. See the table below:"http://www.schmalzhaus.com/EasyDriver/MS1MS2ResolutionlowlowFull Step (2 phase)highlowHalf steplowhighQuarter stephighhighEight step
Hi I have a Stepper Motor 28BYJ-48 that I would like to use it has enough torque to turn my platform that I ran on another program. Waht in the code would I need to change?I know the Stepper Motor 28BYJ-48 each step corresponding to a rotation of 11.25 degrees according to the datasheet. That means there are 32 steps per revolution (360/11.25 = 32). In addition, the manufacturer has specified a gear ratio of 64:1 for the 28BYJ-48 stepper motor. To obtain the final number of steps, the gear ratio must be multiplied by the number of steps per revolution, 32. The more accurate value for the gear ratio is actually about 63.68395 : 1. Therefore, we set the final number of steps to 2038 (32 x 63.68395 = 2037.8864).
where can I find the code in english--Thanks
De-Rust Your Old Table Saw
Arduino+Stepper Motor Camera Slider
DIY MOSFET Motor Controller
Controlling Stepper Motor With L293D
Automated Turntable With Steppermotor
Add an External Trigger Port to Your Camera Flash
I need help with the code for this project I would like to open and close the solenoid on repeat basis I would like to be able to control the time between opening and closing ,Thanks for your help
Sound Activated Camera Flash
Would you have any additional pictures of breadboard layout?
Bi Polar Stepper Motor With L293D and Arduino
I am new to the electronic build is there more information regarding the electronic parts, detailed instruction of the schematics? like how to attach the wires to the dc motor etc.
How to Build the Fastest Quadcopter in 3 Hours
I would like to build this but I cannot open the prt files can the files be saved in a different program extension like Sketchup skp file extension
I use an old golf club bag cart, I cut piece of plywood for the base use bungee cord to hold the tripod in. Works OK when have to transport it a long distance out side.
Homemade Mini Milling Router Mill DIY Z Axis Slide Aluminium Stage Frame CNC for 3D Printer
Homemade Mini Milling Router Mill DIY XYZ Axis Slide CNC
DIY motorized moving timelapse camera dolly with Arduino
Do you have layout diagram for the camera slider parts base and camera platform
Arduino : How to Control Stepper Motor Via Bluetooth (with Smartphone)
The Ultimate PVC Quadcopter
I am looking at building this would you have any drawings of the layout? I see your layout video I do not get sound.