Tell us about yourself!
- billd6 completed the lessons PCB Concepts and Materials and Preparing a Schematic in the class Circuit Board Design Class
- billd6 enrolled in Solar Class
- billd6 completed the lessons Introduction to Fusion 360: Design a Lamp in an Hour, Intro to Fusion 360 UI and Sketch the Lamp in the class Intro to Fusion 360: Lamp Design
- billd6 commented on WoodPlusMore's instructable Articulated Utility Arm
- billd6 completed the lesson Your First Experiments in the class Arduino Class
- billd6 made the instructable Your First ExperimentsView Instructable »
It worked just as expected!
- billd6 completed the lessons Tools and Materials for Arduino and Welcome to Arduino in the class Arduino Class
- billd6 enrolled in Arduino Class
Just curious if you used a 3 inch hole saw which would cut the pucks smaller than 3 inches or you used a larger hole saw to yield a 3 inch diameter puck.