Tell us about yourself!

Complete Your Profile
  • deanhemm commented on mahyuddinchan's instructable Foam Organizer8 weeks ago
    Foam Organizer

    If you are going to use non conductive foam for semi-conductor storage as you have shown in your photos, I would recommend just wrapping it in aluminum foil first and then inserting the parts. Not near as likely to get static damage.

    View Instructable »
  • deanhemm commented on educ8s's instructable Internet Radio Using an ESP323 months ago
    Internet Radio Using an ESP32

    Finally finished. Had more trouble with the case I built from scraps and a bit of burlap than I did with the electronics although there were some challenges there. I learned a lot about the ESP32 in the process. Struggled with finding the right libraries to use.The amp worked fine for me. a bit of tick in the audio but not a worry as I wanted the old time look and sound anyway. I found I could listen to none of the stations you had as default as the stutter was too bad. I live in Australia and the ping to your stations listed was over 300 msec. When I found local stations it worked fine and I could even listen to overseas stations if the bit rate was no higher than 128 kbps.I too had trouble finding station information with mp3 bit rate and port information until I stumbled upon...

    see more »

    Finally finished. Had more trouble with the case I built from scraps and a bit of burlap than I did with the electronics although there were some challenges there. I learned a lot about the ESP32 in the process. Struggled with finding the right libraries to use.The amp worked fine for me. a bit of tick in the audio but not a worry as I wanted the old time look and sound anyway. I found I could listen to none of the stations you had as default as the stutter was too bad. I live in Australia and the ping to your stations listed was over 300 msec. When I found local stations it worked fine and I could even listen to overseas stations if the bit rate was no higher than 128 kbps.I too had trouble finding station information with mp3 bit rate and port information until I stumbled upon fmstream.org. Great site!Thanks again for a fun project and great intro to ESP32 for me.

    View Instructable »
  • deanhemm commented on educ8s's instructable Internet Radio Using an ESP324 months ago
    Internet Radio Using an ESP32

    great project. well presented. Did you manage to clean up the audio? You mentioned you were getting some background noise.

    View Instructable »
  • How to Make an Explosion Box for Christmas | DIY Paper Crafts

    great gift idea. Good video too! Who is the singer btw?

    Sorry I was unclear. The first one in the background of your construction video. A girl? singing a Christmas song?

    View Instructable »
  • deanhemm commented on aalshumemry's instructable The Autonomous Remote Controlled Car12 months ago
    The Autonomous Remote Controlled Car

    Could you specify the part numbers for the IR remote and IR receiver? Very good commenting on your coding btw. Good project.

    View Instructable »
  • deanhemm commented on oliverb's instructable Arduino Perpetual Calendar Clock1 year ago
    Arduino Perpetual Calendar Clock

    Beautiful job! You were very fortunate to find such a lovely case as well. Have you considered using the lower clock as an hour hand only clock rather than a tide clock? It would be of interest to the many of us who live far from the sea. I realize you would need to create a new face as well but as you did such a superb job on this one it is well within your capabilities!

    View Instructable »
  • Minecraft Creeper Sentry With Arduino Uno, Ultrasound and LEDs

    I would like to try this as well. Had a little trouble following your wiring as no schematic however worked it out and drew one up from your excellent creeper control module silk top pdf for pcb. I did not see where you specified the value of the potentiometer but don't think this is particularly critical.

    View Instructable »