Tell us about yourself!
- legonuke04 followed Nightkilla
- legonuke04 favorited Ski Bike by Oblongata
- legonuke04 commented on Oblongata's instructable Ski Bike
- legonuke04 favorited Google Bike by braingram
- legonuke04 followed TimAnderson
- legonuke04 followed JackmanWorks
- legonuke04 commented on mikerobertgodfrey's instructable How to Build a Bicycle FrameView Instructable »
It is possible to set most machines for a low volt, low feedrate. for Miller MIG, I suggest (after practice) 15.2V @ FR 142
- legonuke04 commented on randofo's instructable 3D Printed Measuring SpoonsView Instructable »
It is safe to use, to seal, hold a bic or cutter lighter over it, for a few seconds, then press a marble(or other smooth surface) to it. Or enable ironing in print settings.In terms of dyes, most of them wont effect too much. I have 2 water bottles (lime green PLA) that work fine.
- legonuke04 commented on Nikus's instructable DIY 3D Printed Dremel CNCView Instructable »
While I've never seen this error on the Ender, try updating Cura. It is around v4.4
- legonuke04 commented on ZebranoWoodCraft's instructable Skull Ring DIY
Would it work to use a Fatty tire on the back, and a set of spaced, uncut (161) powder skis on the front? like 6" offset from the forks?