purushottamd3

Yes

in code where should i put the code for 32 relay?

nice project, thanks for sharing ?

i don't have now,i need the circuit then i can make another.my mail id-p8293198287@gmail.com

separately download the library of DHT.h

ok. as soon as i am free i'll upload it.

yes.ofcourse

p8293198287@gmail.comthat's my mailbox.

yah! it almost a year ago.i made my own code to get rid of itself.

yah! it almost a year ago.i made my own code to get rid of it self.😅

yaah it almost a year ago.i made my own code to get rid of it self.😅

how? the code say not to modify them.where i put the code of d11

servo is not workingwhat can i do?

https://www.instructables.com/Arduino-Timer-With-OnOff-Set-Point/

can i powerup my arduino nano with 3.7v battery? it requires 5v regulated or 5v to 12v unregulated.is it possible to use 3.7v on nano?

do you want to hack mobile or control it with phone? replay must

you can use both,but you have to configure the Circuit.if you use pro mini 3.7v then you can operate whole​ Circuit with 3.7v bettery,but i you use uno or nano then you have to use 5v to 12v supply,and have to use resistors for with the help of voltage devider rule and then you can use transistor.their have pro mini 5v also be careful when you purchase.

on output voltage pin in arduino

yes you can. i am facing the same problem,but i am using whole different Circuit and programme

same

by serial monitoringsend below code then tx and rex will be blinking together,and in the out pin if you connect a led with resistor that will lights up"*fly haigher"//with out " "

Circuit diagram is right but the Circuit is wrong that only fly up and downward,because of 1 resistor and pin r shorted,you have to use eache resistor for eache transistor

ask for phero board