Tell us about yourself!

Complete Your Profile
  • sdell624 commented on punkkills's instructable Micro 105 FPV Quadcopter - 3D Printed2 years ago
    Micro 105 FPV Quadcopter - 3D Printed

    Hi punkkills,I've been working on your (awesome) quadcopter project, but recently hit a stumbling block and was wondering if you could help me out a bit. I've gotten to the point where the initial soldering is done (no FPV yet), and my problem (I think) has to do with modes and the transmitter. When I test the motors through Cleanflight, they work fine; however, untethered, the transmitter has no effect on the motors (quadcopter won't fly). When hooked up to Cleanflight, the receiver tab and channel map both check out (signals are getting through), and the scisky and transmitter seem to be bound fine. I think the issue might stem from my AUX channels - I only have three, and the only one I can actively control is controlled by the same stick as my throttle no matter what channel maps I ...

    see more »

    Hi punkkills,I've been working on your (awesome) quadcopter project, but recently hit a stumbling block and was wondering if you could help me out a bit. I've gotten to the point where the initial soldering is done (no FPV yet), and my problem (I think) has to do with modes and the transmitter. When I test the motors through Cleanflight, they work fine; however, untethered, the transmitter has no effect on the motors (quadcopter won't fly). When hooked up to Cleanflight, the receiver tab and channel map both check out (signals are getting through), and the scisky and transmitter seem to be bound fine. I think the issue might stem from my AUX channels - I only have three, and the only one I can actively control is controlled by the same stick as my throttle no matter what channel maps I try - but am not sure. At the moment I have both arm and angle modes set to be on permanently. Any help would be greatly appreciated!Here is a link to my transmitter: http://www.banggood.com/FsFly-T-six-2_4GHz-6CH-DS...P.S. Your advice worked great, although I was stuck for a bit before I realized the scisky will only arm when flat

    View Instructable »
  • sdell624 followed sdell6242 years ago