Tell us about yourself!
You have 2 programs that need to be ran 1 is the Arduino code and 2 is the processing code as you call it , but how are both programs downloaded to the Arduino? I mean I know the Arduino uses sketches or programs to run each project but I am getting confused on how 2 programs are downloaded and ran simultaneously?
does anyone know where in the IDE does one adjust the Baud rate (I know how to set the baud rate in the code but I am referring to the serial plotter) ?? It shows a picture on one of the steps where it says your code and the serial plotter must be set at equal baud rates (and it shows a pic of the baud rate of 9600 and a scroll down) but it doesn't show how to actually adjust the baud rate on the serial plotter. I ASK this question because on several projects now I have been able to build and test many of these projects but could never get results plotted on the plotter.
I did not check the baud rate but I am starting over from scratch this time double checking the baud...I believe the project was working fine except for the graph plotting...I was getting output values on the 16 x 2 lcd with all three sensors responding appropriately to both temperature and skin conductivity .
I cannot get my output to the serial monitor. I copied and pasted sketch as suggested but I only see output on 16 x 2 lcd display, Can anyone help ?