Tell us about yourself!
"A drill press is typically measured by its "swing", calculated as twice the distance from the center of the chuck to the closest edge of the column. Thus, a tool with 4" between chuck center and column edge is described as an 8" drill press."wikipedia.org/wiki/Drill#Drill_pressWhat is the swing of your drill press?
This looks like a good way to start a fire.
I hope you realize this is a technique for attracting giant earthworms, be careful.
"There is no inside handle to close it."Tie a small suction cup to a cord and have it hanging on the jamb.
Nice work, is there an attractive nuisance contest yet?
All posative terminals should be red.
As these are for wood carving would it make sense to grind one blank with a left bevel and the other with a right?
Nice! Is this a 'Royal Navy' monkey fist? Would you show the path from first to second axis?
You seem to just jump into this without any layout or pattern.
You don't list any sources but ebay lists these as welding filler rods at $3 each ...
Nice designs but don't magnets "disable" credit cards?
I would make the plexiglass over the chisels extend down to guard the blades and any passing fingers.
The underside of whatever table you're sitting at.
Lead melts at 621.4°F, 327.5°C
Nice. Is the bottom weighted? It looks like it could tip over with some enthusiastic cat-tivety.
stick a piece of PSA sandpaper to the base of other machines.
I'm concerned with the lack of fastening to the base and the oblique cylinder of your base. I'm talking tipping over while you're wailing away at it.
You need a PFD and a longer paddle.
Number 5 is a bad habit to get into!
PVC -- It's Great for Inventions
Table Saw Class
How to Make a Lei Po'o
Thank you ItsGraGra for pointing this out. The fixed bending edge needs to be set back at least the thickness of the sheet goods or the brake will be 'sprung' when a fold is thrown. This design, with the vertical clamping, would result in the fixed edge being shoved rearwards, the knife edge possibly being swedged up and an inconsistent bend along the middle of the work. Some brake designs use a horizontal bolt adjustment to hold the fixed edge a set distance from the bending line.Thank you Kevanf1, you have put a lot of good work into your construction and Instructable. Locking the clamping edge both verticaly and horozontaly will increase the consistency of your bends.
The platters make good heliographs.
Knex Coin Sorter V2
Automatic 360 Degrees Panorama Shooting Stand
DIY Glow 3D Printer