Introduction: Motorlift
I made this motorlift with the plans i got from a friend.
For mine i changed it a bit , mine is longer and higher than shown in the plans.
It can easily lift my motorbike which ways about 170 kilo.
I also use it a lot as an extra workbench.
Step 1: Floor and Arms
The thickness of the steel is 2mm ,only the two bars between the arms are thicker.
Don't forget to put the unwelded arms in place before you weld them.
Step 2: Tabletop
I have painted the wooden top white for more light reflection.
Step 3: Securing
Securing the table can be done in different ways .
This is how i did it.

Participated in the
Make It Real Challenge
5 Comments
5 years ago
Fabulous!
8 years ago on Introduction
Great Instructable! It looks very sturdy! How much did it cost you to build it?
Thanks,
Lunna
8 years ago on Step 2
Good post!
What is the tube inside a tube shown in the second drawing? I don't see it on picture #1.
Reply 8 years ago on Introduction
Thats how it was on the original plans.
It's supposed to be a solid piece milled down on a lathe.
I don't have a lathe ,so i used a straight piece.
8 years ago on Introduction
This is perfect I could use this for working on my velomobile thank you :-D