Introduction: Ash Catching Beer Can Stick Incense Burner
For this project you will need:
Large beverage can. I will be using 24oz.
Churchkey can opener
Scissors
Stick incense
Step 1: Empty
Drink the beer untill your can is empty. This is themost crucial step.
Step 2: Puncture
Puncture can with churchkey levered from top and side multiple times.
Expand a few punctures down side to vent with scissors:
Step 3: Insert Incense
Swing pull tab over the original top opening.
Slide incense burning side first down gap, but stop before it is touching the bottom. Adjust pull tab to securely grip incense stick:
Look at all that smoke, dude!
Enjoy your now ashless enviroment.
Be the First to Share
Recommendations
Digital Fabrication Student Design Challenge
Go Big Challenge
Stone Concrete Cement Contest
3 Comments
9 years ago on Introduction
Putting the burning side down into the can was the key! I've tried to figure out a fast way to make an incense burner from a can a bunch of times, but I hadn't tried that. Kudos to you.
My pic looks a bit different, because I was too lazy to get up for my can opener, so I just stabbed the can a lot with a pocket knife
/!\ Safety Advisory: Follow the original instructions. /!\ =p
11 years ago on Introduction
Just a horrible phone camera for now, sorry.
Thought the incense burners on here were in that desperate need of an addition.
11 years ago on Introduction
Dude. I must need glasses or something--your pictures are all fuzzy.