Introduction: Easy Cobra Loom Band

This is the " easy cobra loom band"

You will need-

--38 white (or any other colour) loom bands.

--25 dark blue (or any other colour) loom bands.

--24 yellow (or any other colour) loom bands.

--a loom board

--a hook

--S or C clips

Step 1: Step 1

start by having the board with the peg ends pointing towards you. Make a boarder of black. (sorry the 'You will need said white but I am using black)

Step 2: Step 2

It should look like this.

Step 3: Step 3

Now, starting at the point, begin placing the black bands right down the middle. It should look like this when its done.

Step 4: Step 4

When finished, starting in the middle place bands going in a zig-zag pointing left then right then so on.

Step 5: Step 5

It should now look like this.

Step 6: Step 6

Now continue the zig-zag on the other side with yellow but go the opposite way.

Step 7: Step 7

It should now look like this.

Step 8: Step 8

Now put a cap band at the top of the board.


A loom band twisted into and 8 figure and folded in half to make a circle.

Step 9: Step 9

Flip the board around so the yellow is on the left and the blue on the right. Begin looming the bands by pulling the bottom of the band through the peg and over to the peg above it. Do this in the middle column until you reach the end. Continue this pattern on the left column then the right.

Step 10: Step 10

Once the looming the bands flip to the other side of the board and, taking a loom band, thread it through the bands and place the band in the middle of the hook.

Step 11: Step 11

Peel the cobra loom band so that only one peg remans with a loom band/s on it. Using the board, create a single chain bracelet continuing from the cobra bracelet. Place a S or C clip on and admire your fantastic work!

Have fun and Enjoy!

P.S: please comment on your creation.