Interwoven Figure-8-knots Loop

Introduction: Interwoven Figure-8-knots Loop

This is a step-by-step instructions for ABOK 805

Depending on the clip used this loop can be used as a lanyard, zipper pull, key ring fob, etc.

Step 1:

Bring Working End under standing part.

Step 2:

Bring WE back over standing part and up through the bight. This forms the first figure-8-knot.

Step 3:

Turn knot so that standing part is on the left. The Standing End becomes the new WE.

Step 4:

Bring new WE through the figure 8 parallel to the old WE. This forms the loop of your knot.

Step 5:

Bring WE to the left down through the bight and under the side of the loop.

Step 6:

Bring WE down through the bight. This completes the second figure-8-knot. Tighten.

Be the First to Share

    Recommendations

    • Tinkercad Student Design Contest

      Tinkercad Student Design Contest
    • Retro Tech Challenge

      Retro Tech Challenge
    • Space Contest

      Space Contest

    Comments