Introduction: Knex Knife With Sheath
This is my knex knife. I took NatNoBrains knex knife and sheath and modded it so it looks a lot better and so it is a little stronger.
If you like this, please vote for it in the remix contest or in the knives and blades contest.
Step 1: Parts Count
Dark Grey - 21
Light Grey - 5
Orange - 14
Red - 4
Green - 4
Yellow - 8
White - 2
Green - 4
White - 20
Blue - 12
Grey - 1
Bendy Rod (Grey Length) - 1
Metallic Blue Clips - 2
Tan Clips - 17
Silver Spacer - 5
Blue Spacer - 6
Y Clips - 4
Step 2: The Blade
Pic 1: Snap 13 tan clips on a bendy rod.
Pic 2: Add 10 orange connectors between the tan clips.
Pic 3: Snap 12 grey connectors and 2 metallic blue clips onto a grey rod.
Pic 4: Connect the two parts together and add a light grey connector at the end.
Step 3: The Handle
Pic 1: Snap a white connector on the end of the blade.
Pic 2: Add 6 red rods to the white connector.
Pic 3: Put another white connector on the ends of the red rods.
Pic 4: Slide a silver spacer and two blue spacers onto the end of the grey rod and hold them in with a grey connector.
Pic 5: The finished knife.
Step 4: The Sheath
Pic 1: Make two of these sides of the sheath.
Pic 2: Make these small parts.
Pic 3: Slide the small parts into one side of the sheath.
Pic 4: Slide two blue rods with tan clips at the ends in the middle of the sheath.
Pic 5: Add a few spacers on the blue rod.
Pic 6: Snap two blue rods on the end of the sheath and add a few spacers to it.
Pic 7: Slide the other side of the sheath onto the blue rods.
Pics 8 and 9: Hold the sides of the sheath by snapping a few connectors on the blue rods.
Step 5: You Are Done
You have just made a really cool knex knife.